Open/Close TFT Monitor
Press the ( ) button on the front panel or on the remote control to open/close the TFT monitor.
TFT Monitor Auto Open
·If “TFT Auto Open” is “ On”, when the unit is turned on, the monitor automatically moves to the last
viewing position.
·If “TFT Auto Open” is ”Off”, when the unit is turned on, press the ( ) button on the front panel or on
the remote control to move the monitor into the desired viewing position.
·If “TFT Auto Open” is ”Manual”, when the unit is turned on or turned off, the monitor is no any
movement.
See “General setting” for more instructions.
Monitor Tilt Angle Adjustment
The monitor angle can be adjusted for optimum viewing using one of the following methods:
• Press the ( ) or ( ) buttons on the front of the unit to adjust the tilt angle of the screen one step at a
time.
• Press and hold the ( ) or ( ) buttons to continuously adjust the tilt angle.
Rear Camera Mode
When the vehicle is placed in "Reverse", and an optional re ar camera is connected to the unit, the TFT
monitor will automatically switch to the camera input source.
Image Setting
Video Output Format
The nether table shows the video output format for each playing source.
Video Output Format
*CVBS-- Composite Video Base band Signal
Adjustable Parameters
While in RGB mode, the only parameter that can be adjusted is brightness (BRIGHT). To access
“PICTURE”,“COLOR”, “CONTRAST”, and “ BRIGHT you must be in CVBS mode.
Parameter Adjustment Procedure
1. Enter Picture Quality Setting mode:
Press the PIC button on the remote or press and hold the INFO button on the unit.
2. Select Item to Set:
Press the / buttons on the remote or rotate the ENTER button clockwise/anticlockwise to select a
item.
3. Set Parameters:
Press the / buttons on the remote or press the ANGLE button ( / ) on the front panel to
adjust the selected feature to the desired setting.
4. Exit Picture Quality Setting Mode:
Press the PIC button on the remote or press and hold the INFO button on the unit.
Comments to this Manuals